Circuit/System Verification: Notes
WARNING: This page is about a different variant/trim than selected.
- Verify that other DTCs are not set.
- If any other DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Ignition ON, engine OFF, observe the manifold absolute pressure (MAP) sensor parameter. The MAP sensor pressure should be within the range specified for your altitude. Refer to Altitude Versus Barometric Pressure
.
- If the MAP sensor does not indicate the correct barometric pressure, refer to DTC P0106 .
- With the engine idling, observe the mass air flow (MAF) sensor parameter. The MAF sensor parameter should be between 2-6 g/s at idle.
- If the MAF sensor parameter is not between 2-6 g/s at idle, refer to DTC P0101 or P1101 or DTC P0102 or P0103 .