Static Test
WARNING: This page is about a different variant/trim than selected.
- Ignition OFF, remove the Camshaft Position Actuator Magnet.
- Test for 4.6-5.2 Ω between the solenoid control terminal 1 and the low reference terminal 2 at the Camshaft Position Actuator Magnet.
- If not within the specified range, replace the Camshaft Position Actuator Magnet.
- Test for infinite resistance between each terminal of the magnet and the magnet housing.
- If not the specified value, replace the Camshaft Position Actuator Magnet.
NOTE:
Ensure that the component is tested at 20°C (68°F).