LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 3.5L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying EVAP Canister Vent Solenoid Valve Bracket Bolt
    GM1618940Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister vent solenoid valve.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the EVAP canister vent solenoid valve bracket bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    3. Fig 2: EVAP Canister Vent Solenoid Valve And EVAP Emission Canister Hose
    GM1618911Courtesy of GENERAL MOTORS CORP.
  3. Connect the EVAP canister vent solenoid valve to the EVAP emission canister hose.
    4. Fig 3: EVAP Canister Vent Solenoid Valve Electrical Connector
    GM1618963Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP canister vent solenoid valve electrical connector.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals