Removal Procedure

WARNING: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

Remove the hood. Refer to Hood Replacement .
Remove the rear hood side seal. Refer to Hood Rear Outer Seal Replacement .
Remove the hood assist rod. Refer to Hood Open Assist Rod Replacement .

Fig 1: Hinge Bolts

Courtesy of GENERAL MOTORS CORP.

Loosen the hood hinge to fender bolts, but do not remove the bolts.

Fig 2: Center Punching Spot Weld

Courtesy of GENERAL MOTORS CORP.

Center punch the spot weld

Fig 3: Drilling Hood Hinge Spot Weld

Courtesy of GENERAL MOTORS CORP.

Drill out the spot weld using a 9.5 mm (3/8 in) drill bit.
Remove the hood hinge to fender bolts.
Remove the hood hinge from the fender.
Repair the paint on the fender where the hood hinge was removed. Refer to Anti-Corrosion Treatment and Repair .