LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Hood Hinge Replacement >> Installation Procedure

Installation Procedure

NOTE: Weld on body side is an assembly plant assembly aid only. Weld is not required when installing a replacement hinge.
    Fig 1: Hinge Bolts
    GM363782Courtesy of GENERAL MOTORS CORP.
  1. Install the hood hinge to the fender.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the hood hinge to the fender bolts.

    Tighten:  Tighten the hood hinge to fender bolts to 25 N.m (18 lb ft).

  3. Install the rear hood side seal. Refer to Hood Rear Outer Seal Replacement .
  4. Install the hood assist rod. Refer to Hood Open Assist Rod Replacement .
  5. Install the hood. Refer to Hood Replacement .
  6. Adjust the hood as required. Refer to Hood Adjustment .
scientia non olet · About LEMON Manuals