LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> HHR LS, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays And Gauges >> Diagnostic Information and Procedures >> DTC P0462 >> Circuit/System Testing

Circuit/System Testing

NOTE:

If equipped, the following tests can be performed at an inline connector. See schematics for the corresponding terminals to test at.

  1. Ignition OFF, disconnect the harness connector at the fuel level sensor.
  2. Ignition ON, verify that the scan tool Fuel Tank Level Remaining parameter is less than 4 percent.
    • If greater than the specified range, test the signal circuit terminal C for a short to ground. If the circuit tests normal, replace the ECM.
  3. If all circuits test normal, perform the fuel level sensor component test before replacing the fuel level sensor.
scientia non olet · About LEMON Manuals