Circuit/System Verification
IMPORTANT:
Before performing this diagnostics, make sure no indicator(s) are illuminated after the IPC performs a lamp test. If any indicators are illuminated after the bulb test, perform the indicator diagnostics before this diagnostics.
- Ignition ON, headlamp switch OFF, verify the scan tool Headlamp Switch parameter is Inactive.
- If not Inactive, refer to Headlamps Malfunction .
- Ignition ON, doors closed, verify the scan tool All Door Lock Command is On.
- If not On, refer to Courtesy Lamps Malfunction .
- Ignition ON, radio ON, adjust the radio balance and fade to the left front speaker.
- If the speaker does not operate properly, refer to Speaker Malfunction
- Verify that the Key In Ignition Cylinder Switch parameter is Yes when the key is in the ignition and No when the key is out of the ignition.