Engine Front Crossmember Replacement (RWD)

Engine Front Crossmember Replacement (RWD)


Removal Procedure





1.Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

2.Disconnect the electrical wiring harness connectors from the engine crossmember.

3.Remove the engine crossmember mounting bolts.

4.Remove the engine crossmember.

Installation Procedure





1.Install the engine crossmember.

Caution:Refer to Fastener Caution .

2.Install the engine crossmember mounting bolts.

-LD 14,200 lb GVW, tighten the bolts to120 N �m (89 lb ft).

-CA 14,200 lb GVW, tighten the bolts to85 N �m (63 lb ft) plus 90 degrees.

-HD and CA, tighten the bolts to135 N �m (100 lb ft)

3.Connect the electrical wiring harness connectors to the engine crossmember.

4.Lower the vehicle.