Special Tools

EN-6009:  Remover and Installer Ignition Module

For equivalent regional tools, refer to Special Tools .

Fig 1: Ignition Coil And Remover And Installer
Courtesy of GENERAL MOTORS CORP.
1. Install the ignition coil (1) and remove EN-6009:  remover and installer (2).
Fig 2: Ignition Coil Bolts
Courtesy of GENERAL MOTORS CORP.
CAUTION: Refer to Fastener Caution .
2. Install the 2 ignition coil bolts (1) and tighten to 8 N.m (71 lb in).