Drive Belt Installation

Special Tools

• EN-955-2:  Locking Pin
• EN-48488:  Holding Wrench

For equivalent regional tools, refer to Special Tools .

NOTE: Ensure that the drive belt tensioner is held with EN-955-2:  locking pin.
1. Install the drive belt.
Fig 1: Locking Pin And Wrench
Courtesy of GENERAL MOTORS CORP.
2. Move the drive belt tensioner clockwise until EN-955-2:  locking pin (2) can be removed. Use EN-48488:  wrench (1).
3. Remove EN-955-2:  locking pin (2) from the drive belt tensioner while holding with EN-48488:  wrench (1).
4. Release tension from drive belt tensioner and remove EN-48488:  wrench (1).