LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Cruze LT >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 1.4L (LDD, LDU, LUH, Or LUJ) - Repair Instructions - Off Vehicle (2 Of 2) >> Camshaft Position Actuator Solenoid Valve Installation

Camshaft Position Actuator Solenoid Valve Installation

    Fig 1: Camshaft Position Actuator Solenoid Valves And Seal Rings
    GM2190650Courtesy of GENERAL MOTORS CORP.
    CAUTION: The camshaft position actuator solenoid valves must be kept parallel to the engine front cover during removal and installation. The camshaft position actuator solenoid valves can be damaged if they become wedged or stuck during this process.
  1. Install the 2 camshaft position actuator solenoid valves (2) and the 2 seal rings (1) by carefully and evenly pressing.
    2. Fig 2: Camshaft Position Actuator Solenoid Valve Bolts
    GM2191735Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution
  2. Install the 4 camshaft position actuator solenoid valve bolts (1) and tighten to 8 N.m (71 lb in).
    3. Fig 3: Camshaft Position Actuator Solenoid Valves Proper Position
    GM2190651Courtesy of GENERAL MOTORS CORP.
  3. The 2 camshaft position actuator solenoid valves should be installed in the position as shown (1) and (2).
scientia non olet · About LEMON Manuals