Rear Side Door Trim Replacement

Fig 1: Identifying Rear Side Door Trim Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Rear Side Door Inside Handle Bolt Finish Cap Procedure: Pull handle back to remove cap. Use suitable tool to unsnap.
2	Rear Side Door Inside Handle Screw CAUTION: Refer to Fastener Caution . Tighten: 2.5 N.m (23 lb in)
3	Rear Side Door Pull Handle Screw Tighten: 2.5 N.m (23 lb in)
4	Rear Side Door Trim Clip (Qty: 5) Special Tools: BO-38778: Door Trim Panel Clip Remover For equivalent regional tools, refer to Special Tools
5	Rear Side Door Trim Assembly Procedure Pull upwards on the door lock retainer cable to disengage. Disconnect the electrical connectors. Tip: Only use BO-38778: remover to disengage the door trim clips from the door. Do not disengage the clips by pulling from the map pocket area, since this can distort the trim panel.