Front Side Door Trim Replacement

Fig 1: Locating Front Side Door Trim Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures: Remove the front side door upper trim cover. Refer to Front Side Door Upper Trim Cover Replacement .
1	Front Side Door Pull Handle Bolt CAUTION: Refer to Fastener Caution . Tighten: 2 N.m (18 lb in)
2	Front Side Door Inside Handle Bolt Finish Cap Procedure: Pull handle back to remove cap. Use suitable tool to unsnap.
3	Front Side Door Inside Handle Bolt Tighten: 2.5 N.m (22 lb in)
4	Front Side Door Trim Clip (Qty: 10) Special Tools: BO-38778: Door Trim Panel Clip Remover For equivalent regional tools, refer to Special Tools .
5	Front Side Door Trim Procedure Pull upwards on the door lock retainer cable to disengage. Disconnect the electrical connectors. Tip: Only use BO-38778: remover to disengage the door trim clips from the door. Do not disengage the clips by pulling from the map pocket area, since this can distort the trim panel.