LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Cruze LS, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 1.8L (2H0 Or LUW) - Troubleshooting & Diagnosis >> Diagnostic Information and Procedures >> Cylinder Leakage Test (1.6L LDE, LXV, 1.8L 2H0, and LUW) >> Removal Procedure

Removal Procedure

  1. Open the hood.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the front compartment splash shield. Refer to Front Compartment Splash Shield Replacement
  4. Lower the vehicle.
  5. Remove the timing belt upper front cover. Refer to Timing Belt Upper Front Cover Removal (1.6L LDE, LXV, 1.8L 2H0, and LUW) .
  6. Remove the spark plugs. Refer to SPARK PLUG REPLACEMENT .
  7. Detach the engine wiring harness from intake manifold, cylinder head cover and engine wiring harness bracket.
  8. Remove the coolant expansion tank closure cap.
  9. Remove the oil dipstick.
    10. Fig 1: View Of Crankshaft TDC Position
    GM1936993Courtesy of GENERAL MOTORS CORP.
  10. Set up the crankshaft.
  11. Move the crankshaft in the direction of the engine rotation to the first cylinder TDC position (mark 1).
    12. Fig 2: View Of Guidance Marks
    GM1945804Courtesy of GENERAL MOTORS CORP.
  12. Apply guidance marks.
  13. Attach 3 markings (2) as an aid to one of the camshaft adjusters, each one offset by 90° to the marking applied (1).
scientia non olet · About LEMON Manuals