LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Cruze LS, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 1.8L (2H0 Or LUW) - Repair Instructions - Off Vehicle (2 Of 2) >> Ignition Coil Installation >> Special Tools

Special Tools

EN-6009:  Remover/Installer Ignition Module

For equivalent regional tools, refer to Special Tools .

    Fig 1: Ignition Coil Module And Special Tool
    GM2026537Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition coil module (2) with the EN-6009:  remover/installer (1).
  2. Remove the EN-6009:  remover/installer (1).
    3. CAUTION: Refer to Fastener Caution
    NOTE: Note the arrow on the cover.
  3. Install the 2 ignition coil bolts an tighten to 8 N.m (71 lb in).
    4. NOTE: Note the arrow on the cover.
  4. Install the cover of the DIS ignition coil against the direction of the arrow.
scientia non olet · About LEMON Manuals