Special Tools

EN-652:  Automatic Transmission Flex Plate Holder

For equivalent regional tools, refer to Special Tools .

1. Clean the automatic transmission flex plate bolt threads.
Fig 1: Automatic Transmission Flex Plate And Holder
Courtesy of GENERAL MOTORS CORP.
2. Install the automatic transmission flex plate (2) and the EN-652:  holder to hold the automatic transmission flex plate (2).
Fig 2: Automatic Transmission Flex Plate
Courtesy of GENERAL MOTORS CORP.
CAUTION: Refer to Fastener Caution .
3. Install the 6 NEW automatic transmission flex plate bolts (2) and tighten the bolts to 60 N.m (44 lb ft) ± 5°.
4. Remove the EN-652:  holder.