Special Tools

EN-652:  Automatic Transmission Flex Plate Holder

For equivalent regional tools, refer to Special Tools .

Fig 1: Automatic Transmission Flex Plate And Holder
Courtesy of GENERAL MOTORS CORP.
1. Install the EN-652:  holder (1) to hold the automatic transmission flex plate (2).
2. Loosen the 6 automatic transmission flex plate bolts.
3. Remove the EN-652:  holder (1).
Fig 2: Automatic Transmission Flex Plate
Courtesy of GENERAL MOTORS CORP.
4. Remove the 6 automatic transmission flex plate bolts (2).
5. Remove the automatic transmission flex plate (1).