Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition OFF, remove the Q8 control solenoid valve assembly. Refer to Control Solenoid Valve and Transmission Control Module Assembly Replacement .
- Perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection .
- Place the Q8 control solenoid valve assembly on a clean work surface near the transmission assembly.
- Connect DT-47825-10: jumper harness between the vehicle wire harness electrical connector, and the Q8 control solenoid valve assembly electrical connector.
- Ignition ON, verify with a scan tool the following test status parameters display OK:
- Shift Solenoid Valve 1 Control Circuit High Voltage Test Status
- Shift Solenoid Valve 1 Control Circuit Open Test Status
- Shift Solenoid Valve 1 Control Circuit Low Voltage Test Status
- If any test status parameter displays Fault or Malfunction, replace the Q8 control solenoid valve assembly.
NOTE:
You must perform the Circuit/System Verification first.