LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Corvette ZR-1 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Automatic Transmission - 6L80-E - DTC P0562 Through DTC P0990) >> DTC P0877 or P0878 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Engine idling in Park with parking brake applied, and drive wheels chocked.
  2. Monitor the Transmission Fluid Pressure Switch 1, Transmission Fluid Pressure Switch 3, Transmission Fluid Pressure Switch 4, and Transmission Fluid Pressure Switch 5 parameters with a scan tool.
  3. Place the gear select lever in Park, Reverse, and Neutral range. Verify the TFP switch parameter states are correct for each range. Refer to Transmission Fluid Pressure Switch Logic .
  4. Place the gear select lever in Drive range. Command the shift transmission with a scan tool through all forward ranges. Verify the TFP switch parameter states are correct for each range. Refer to Transmission Fluid Pressure Switch Logic .
  5. Operate the vehicle within the conditions for running the DTC to verify the TDC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals