Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

Not other ECM or TCM DTCs are set.
Ignition voltage is 8.6 volts or greater.
The engine speed is greater than 400 RPM.
The engine run time is greater than 5 seconds.
High Side Driver (HSD) 1 is enabled.
Accelerator pedal position signal is valid.
The TCM must receive a valid torque signal from the ECM.
Throttle position is 0.5 percent or greater.
Transmission fluid temperature (TFT) is -6.6°C (20°F) or greater.