Low and Reverse Clutch Piston Removal
WARNING: This page is about a different variant/trim than selected.
Low and Reverse Clutch Piston Removal
| Callout | Component Name |
|---|---|
| 1 | Low and Reverse Clutch Spring Retaining Ring
CAUTION:
Ensure the DT 47779 contacts the sprag assembly and not the sprag retaining ring. Damage to the sprag may result. Special Tool: DT 47779: Clutch Spring Compressor For equivalent regional tools, refer to Special Tools . |
| 2 | Low Clutch Sprag Assembly |
| 3 | Low and Reverse Clutch Spring |
| 4 | Low and Reverse Clutch Piston Assembly Tip: It may be necessary to apply air to the apply passage in order to unseat the piston. |
| 5 | Low Clutch Sprag Seal
CAUTION:
Refer to Seal Reuse Caution
.
|