Fluid Pump Cover Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Fluid Pump Cover Components & Bolt Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Fluid Pump Cover Assembly
2	Fluid Pump Cover Bolt M6 x 40 (Qty: 13) Tip: Hand tighten only.
3	Alignment Tool and Bolt CAUTION: Refer to Fastener Caution . Procedure Center the J 46664: pump cover alignment tool around the fluid pump cover assembly in the 9 o'clock position and tighten the alignment bolt. Tighten the fluid pump cover bolts in the sequence shown. Tighten: 11 N.m (97 lb in) Special Tool: J 46664: Pump Cover Alignment Tool For equivalent regional tools, refer to Special Tools .
4	NEW 1-2-3-4 and 3-5 Reverse Clutch Housing Thrust Washer