Control Valve Body Assembly Removal

WARNING: This page is about a different variant/trim than selected.

Fig 1: Control Valve Body

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Bolt M5 x 73 (Qty: 6) Tip: Do not remove all the bolts in the control valve body assembly. Remove only the bolts indicated. Special Tool: DT-48285: Valve Body Torx Plus Socket (if applicable) For equivalent regional tools, refer to Special Tools .
2	Control Valve Body Assembly CAUTION: Use care when handling the control valve body assembly. If dropped, damage to the control solenoid valve body assembly internal components, including the transmission control module (TCM), may result.
3	Fluid Pump Seal Assembly CAUTION: Use care when removing the seal assemblies to avoid damaging the valve body seal bores. CAUTION: Refer to Seal Reuse Caution .
4	Fluid Pump Seal Assembly CAUTION: Use care when removing the seal assemblies to avoid damaging the valve body seal bores. CAUTION: Refer to Seal Reuse Caution .
5	Center Support Fluid Passage Seal Assembly CAUTION: Use care when removing the seal assemblies to avoid damaging the case seal bores. CAUTION: Refer to Seal Reuse Caution .