Control Valve Body Assembly Installation
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| 1 | NEW Fluid Pump Seal Assembly |
| 2 | NEW Fluid Pump Seal Assembly |
| 3 | NEW Center Support Fluid Passage Seal Assembly |
| 4 | Control Valve Body Assembly
CAUTION:
The control valve body assembly needs to be lowered into place vertically, with no lateral movement. Lateral movement can damage the pass through connector pins and/or the oil transfer seals. Tip: Align the manual shift shaft position switch activator slide with the detent lever guide pin. |
| 5 | Bolt M5 x 73 (Qty: 6)
CAUTION:
Refer to Fastener Caution
. Procedure: Tighten in the sequence shown. Tighten: 8 N.m (71 lb in) Special Tool: DT-48285: Valve Body Torx Plus Socket (if applicable) For equivalent regional tools, refer to Special Tools . |