LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Corvette ZR-1 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Automatic Transmission - 6L80-E - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Control Valve Body Assembly Disassemble >> Input and Output Speed Sensor Assembly Removal

Input and Output Speed Sensor Assembly Removal

WARNING: This page is about a different variant/trim than selected.
Fig 1: Input & Output Speed Sensor Assembly Component View
GM1627571Courtesy of GENERAL MOTORS CORP.
Input and Output Speed Sensor Assembly Removal

Callout Component Name
1 Bolt M6 x 20 (Qty: 2)
2 Speed Sensor Electrical Connector
Tip:  Release the connector lock before disconnecting.
3 A/Trans Input and Output Speed Sensor Assembly
4 A/Trans Input and Output Speed Sensor Wiring Harness Clip (Qty: 2)
Tip:  Inspect the clips and replace if damaged.
scientia non olet · About LEMON Manuals