LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Corvette ZR-1 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Automatic Transmission - 6L80-E - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Control Valve Body Assembly Assemble >> Control Solenoid Valve Assembly Contact Gap Inspection

Control Solenoid Valve Assembly Contact Gap Inspection

WARNING: This page is about a different variant/trim than selected.
Fig 1: Control Solenoid Valve Assembly
GM1681608Courtesy of GENERAL MOTORS CORP.
Control Solenoid Valve Assembly Contact Gap Inspection

Callout Component Name
1 Control Solenoid (w/Body and TCM) Valve Assembly
Tip:  Inspect the contact area between the "heat sink" area of the control solenoid valve assembly and the valve body. There should be no visible gap. If a gap exists, loosen all 18 bolts and retighten in the required sequence.
scientia non olet · About LEMON Manuals