3-5 Reverse Clutch Backing Plate Retaining Ring Measurement

WARNING: This page is about a different variant/trim than selected.

Fig 1: Measuring 3-5 Reverse Clutch Backing Plate Retaining Ring

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Install the 1-2-3-4 and 3-5 reverse clutch housing with the 1-2-3-4 and 3-5 reverse clutch plates installed, onto the torque converter housing. Install the DT 47868-2: magnetic base adapter onto the torque converter housing. Install DT 47868-1: clutch pack travel weight onto the 3-5 reverse clutch backing plate. Install the J 26900-13: magnetic base onto DT 47868-2: magnetic base adapter. Attach the J 8001: dial indicator set to the J 26900-13: magnetic base and zero out the dial indicator on the DT 47868-1: clutch pack travel weight. Special Tools DT 47868-1: Clutch Pack Travel Weight DT 47868-2: Magnetic Base Adapter J 8001: Dial Indicator Set J 26900-13: Magnetic Base For equivalent regional tools, refer to Special Tools .
1	3-5 Reverse Clutch Apply Passage Tip: Apply compressed air to the apply passage hole, and observe the dial indicator measurement. Refer to Clutch Backing Plate Retaining Ring Specifications (6L80) .

Callout

Component Name

Preliminary Procedures

Install the 1-2-3-4 and 3-5 reverse clutch housing with the 1-2-3-4 and 3-5 reverse clutch plates installed, onto the torque converter housing.
Install the DT 47868-2: magnetic base adapter onto the torque converter housing.
Install DT 47868-1: clutch pack travel weight onto the 3-5 reverse clutch backing plate.
Install the J 26900-13: magnetic base onto DT 47868-2: magnetic base adapter.
Attach the J 8001: dial indicator set to the J 26900-13: magnetic base and zero out the dial indicator on the DT 47868-1: clutch pack travel weight.

Special Tools

For equivalent regional tools, refer to Special Tools .

3-5 Reverse Clutch Apply Passage
Tip: Apply compressed air to the apply passage hole, and observe the dial indicator measurement. Refer to Clutch Backing Plate Retaining Ring Specifications (6L80) .