LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Corvette ZR-1 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transmission - 6L80-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Fluid Cooler Hose/Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Install a drain pan under the vehicle.
    3. Fig 1: Upper & Lower Transmission Oil Cooler Lines
    GM1503871Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the upper transmission oil cooler line from the upper intermediate line. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  4. Disconnect the lower transmission oil cooler line from the lower intermediate line. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
    5. Fig 2: Upper & Lower Transmission Line Front Clip
    GM1503873Courtesy of GENERAL MOTORS CORP.
  5. Remove the clip holding the front upper and lower transmission lines.
    6. Fig 3: Upper & Lower Transmission Oil Cooler Lines
    GM1503922Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the upper transmission oil cooler line from the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  7. Disconnect the lower transmission oil cooler line from the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  8. Remove the right motor mount. Refer to Engine Mount Replacement - Right Side .
    9. Fig 4: Transmission Oil Cooler Lines & Bolts
    GM1503860Courtesy of GENERAL MOTORS CORP.
  9. Remove the front transmission oil cooler line bolts.
  10. Remove the front transmission oil cooler lines from the vehicle.
scientia non olet · About LEMON Manuals