No Third, Fifth, and Reverse Gear

WARNING: This page is about a different variant/trim than selected.

Checks	Causes
Automatic Transmission Fluid Pan (29)	Verify proper fluid level and condition, inspect transmission assembly for leaks.
Control Valve Upper Body (304)	Inspect for sticking, damaged, or worn R-1/4-5-6 clutch regulator valve (327) and spring (326). Inspect for damaged or stuck #7 ball check valve.
Control Valve Lower Body (307)	Inspect for worn, damaged, or sticking clutch select solenoid valve 3 (352) and valve spring (353).
1-2-3-4 and 3-5-Reverse Clutch (51)	Inspect for proper installation of 3-5-R clutch backing plate retaining ring (400). Inspect for worn, damaged, or leaking clutch bearing seal assembly (428). Inspect for damaged or worn 3-5-R clutch plates (401 - 404). Inspect for damaged 3-5-R clutch piston (421), apply ring (405), and spring (420). Inspect for cut, worn, or damaged 3-5-R clutch piston dam O-ring seal (418), inner seal (419), and outer seal (422). Inspect for improper selective 3-5-R clutch backing plate retaining ring (400).
Control Valve Solenoid Body (314)	Pressure control solenoid 2 commanded/failed HIGH (off) or leaking - Perform solenoid valve assembly function test. Refer to Control Solenoid Valve and Transmission Control Module Assembly Solenoid Performance Test .
Automatic Transmission Fluid Pump Seal (19)	Inspect for damage or leaks.