LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Corvette ZR-1 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 6.2L Or 7.0L - Repair Instructions - Off Vehicle (4 Of 5) >> Oil Level Indicator and Tube Installation (6.2L LS3)

Oil Level Indicator and Tube Installation (6.2L LS3)

    Fig 1: Oil Level Indicator Tube
    GM639837Courtesy of GENERAL MOTORS CORP.
  1. Inspect the O-ring seal for cuts or damage. If the oil level indicator tube O-ring seal is not cut or damaged, it may be used again.
  2. Lubricate the O-ring seal with clean engine oil.
  3. Install the O-ring seal onto the oil level indicator tube.
  4. Install the oil level indicator tube into the engine block and rotate into proper position.
    5. CAUTION: Refer to Fastener Caution .
  5. Install the tube bolt. Tighten the oil level indicator tube bolt to 25 N.m (18 lb ft).
  6. Install the oil level indicator into the tube.
scientia non olet · About LEMON Manuals