LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Corvette ZR-1 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 6.2L Or 7.0L - Repair Instructions - Off Vehicle (4 Of 5) >> Engine Block Valley Cover Installation

Engine Block Valley Cover Installation

    Fig 1: Valley Cover Seals & Gasket
    GM1552536Courtesy of GENERAL MOTORS CORP.
    NOTE: All gasket surfaces should be free of oil or other foreign material during assembly.
  1. Lubricate the O-ring seals (537) with clean engine oil.
  2. Install the O-ring seals (537) to the cover.
    3. Fig 2: View Of Cover, Gasket, And Bolts
    GM1559897Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Install the cover (555), gasket (556), and bolts (506). Tighten the cover bolts to 25 N.m (18 lb ft).
    4. Fig 3: Oil Pressure Sensor & Washer
    GM1408864Courtesy of GENERAL MOTORS CORP.
  4. Apply sealant GM P/N 12346004 (Canadian P/N 10953480), or equivalent, to the threads of the sensor.
  5. Install the oil pressure sensor (706) and sealing washer (707). Tighten the sensor to 35 N.m (26 lb ft).
scientia non olet · About LEMON Manuals