LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Corvette ZR-1 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 6.2L Or 7.0L - Repair Instructions - Off Vehicle (1 Of 5) >> Valve Rocker Arm Cover Removal - Right Side (6.2L LS3)

Valve Rocker Arm Cover Removal - Right Side (6.2L LS3)

    Fig 1: Spark Plug Wires, Ignition Coil Bracket Assembly & Bolts
    GM1408867Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not remove the oil fill tube from the cover unless service is required. If the oil fill tube has been removed from the cover, install a NEW tube during assembly.
  1. Remove the spark plug wires (724).
  2. Remove the ignition coil bracket studs (720).
  3. Remove the ignition coil and bracket assembly (719).
    4. Fig 2: View Of Bracket, Bolts, Coils & Wire Harness
    GM1402020Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the ignition coil electrical connectors.
  5. Remove the bolts (723), coils (722), and wire harness (721) from the bracket, as required.
    6. Fig 3: Valve Rocker Arm Cover & Bolt
    GM1559859Courtesy of GENERAL MOTORS CORP.
  6. Remove the valve rocker arm cover bolts (516) and cover (505).
  7. Remove and discard the valve rocker arm cover gasket, valve rocker arm cover grommets and valve rocker arm cover bolts if they are serviced with the grommet.
    8. Fig 4: View Of Valve Rocker Arm Cover Gasket
    GM1272820Courtesy of GENERAL MOTORS CORP.
  8. Remove the gasket (504) from the cover.
    9. Fig 5: Oil Fill Cap & Oil Fill Tube
    GM1559860Courtesy of GENERAL MOTORS CORP.
  9. Remove the oil fill cap (424) from the oil fill tube (423).
  10. Remove the oil fill tube, as required.
  11. Discard the oil fill tube (423) and O-ring (422).
scientia non olet · About LEMON Manuals