LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Corvette ZR-1 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 6.2L Or 7.0L - Repair Instructions - Off Vehicle (1 Of 5) >> Cylinder Head Removal - Left Side

Cylinder Head Removal - Left Side

    Fig 1: Cylinder Head & Bolts
    GM1408868Courtesy of GENERAL MOTORS CORP.
    NOTE: The cylinder head bolts are of a torque-to-yield design and are NOT to be used again. Install NEW cylinder head bolts during assembly.
  1. Remove the cylinder head bolts (220, 221).
    2. CAUTION: After removal, place the cylinder head on 2 wood blocks in order to prevent damage to the sealing surfaces.
  2. Remove the cylinder head (218).
    3. Fig 2: View Of Cylinder Head Gasket & Locating Pin - Left
    GM1408869Courtesy of GENERAL MOTORS CORP.
  3. Remove the gasket (217) and locating pins (230).
  4. Discard the gasket and cylinder head bolts.
scientia non olet · About LEMON Manuals