LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Corvette ZR-1 >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Controls And Fuel - 6.2L Or 7.0L - Repair Instructions >> Repair Instructions >> Knock Sensor Replacement (Bank 1) >> Removal Procedure

Removal Procedure

    Fig 1: Identifying Knock Sensor (Bank 1) Components
    GM1480894Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (LS7 or LS9) or Battery Negative Cable Disconnection and Connection (LS3) .
  2. Remove the left catalytic convertor. Refer to Catalytic Converter Replacement - Left Side (LS7) or Catalytic Converter Replacement - Left Side (LS3) .
  3. Remove the left exhaust manifold. Refer to Exhaust Manifold Replacement - Left Side (LS7 or LS9) or Exhaust Manifold Replacement - Left Side (LS3) .
  4. Remove the mounting bolt for the knock sensor 1.
  5. Disconnect the electrical connector of the knock sensor from the engine harness (3).
  6. Remove the knock sensor (2) from the engine block (4).
scientia non olet · About LEMON Manuals