Rear Bumper Fascia Replacement

Fig 1: Rear Bumper Fascia

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the rear fascia extension. Refer to Rear Bumper Fascia Extension Replacement . Remove the tail lamps. Refer to Tail Lamp Replacement .
1	Rear Bumper Fascia Screw (Qty: 6) CAUTION: Refer to Fastener Caution . Tighten: 2 N.m (18 lb in)
2	Rear Bumper Fascia Screw (Qty: 4) Tip: These screws are accessed through the tail lamp holes. Tighten: 5 N.m (44 lb in)
3	Rear Bumper Fascia Nut (Qty: 4) Tighten: 5 N.m (44 lb in)
4	Rear Bumper Fascia Screw (Qty: 2) Tighten: 5 N.m (44 lb in)
5	Rear Bumper Fascia Screw (Qty: 2) Tighten: 1 N.m (9 lb in)
6	Rear Bumper Fascia Tip: Disconnect any electrical connectors. Transfer any parts as needed.