Circuit/System Verification
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
With scan tool installed, clear the DTCs. Turn the steering wheel through its full range and back to straight ahead to center the steering angle sensor. Using a scan tool, observe the Steering Wheel Position parameter changes smoothly while turning steering wheel through the entire range. Correlate zero reading with wheels in the straight ahead position. Drive the vehicle through a variety of maneuvers turning to the left, right and then straight ahead at a speed greater than 20 km/h (13 mph).
- If the DTC did not set as a current DTC see diagnostic aids.