LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Corvette Z06 >> Repair and Diagnosis >> External Pages >> Different car >> Section 406 (Antilock Brake System - Non-Hybrid Less Than 3900 Kg (8600 Lb) GVW) >> Diagnostic Information and Procedures >> DTC B2745 >> Component Testing

Component Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the traction control switch or the multifunction switch-I/P.
  2. Test for infinite resistance between the signal terminal 1 and the appropriate ground terminal listed below with the switch in the open position.
    • Terminal 3 (with X88 or Z88)
    • Terminal 5 (with Z75)
    • If not the specified value, replace the traction control switch or the multifunction switch-I/P.
  3. Test for less than 5 Ω between the signal terminal 1 and the appropriate ground terminal listed below with the switch in the closed position.
    • Terminal 3 (with X88 or Z88)
    • Terminal 5 (with Z75)
    • If greater than the specified range, replace the traction control switch or the multifunction switch-I/P.
scientia non olet · About LEMON Manuals