LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Corvette Z06 >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Controls And Fuel - 6.2L Or 7.0L - Repair Instructions >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement (Without LS9) >> Removal Procedure

Removal Procedure

    Fig 1: Oil Filler Cap, Right Sight Shield, MAP Sensor & Electrical Connector
    GM1464034Courtesy of GENERAL MOTORS CORP.
  1. Remove the oil filler cap (1).
  2. Remove the right engine sight shield (2).
  3. Remove the manifold absolute pressure (MAP) sensor (4).
  4. Disconnect the electrical connector (3) for the MAP sensor.
scientia non olet · About LEMON Manuals