LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Corvette Z06 >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Controls And Fuel - 6.2L Or 7.0L - Repair Instructions >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: EVAP Canister Access Cover
    GM561137Courtesy of GENERAL MOTORS CORP.
  1. Remove the right rear wheelhouse panel. Refer to Rear Wheelhouse Panel Liner Replacement .
  2. Remove the evaporative emission (EVAP) canister access cover.
  3. Disconnect the fuel tank pressure sensor electrical connector.
  4. Remove the fuel tank pressure sensor by carefully prying the sensor out of the fuel tank with a screwdriver.
scientia non olet · About LEMON Manuals