LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Corvette Z06 >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Controls And Fuel - 6.2L Or 7.0L - Repair Instructions >> Repair Instructions >> Evaporative Emission Line Replacement - Engine (Vent) >> Removal Procedure

Removal Procedure

    Fig 1: View Of EVAP Canister Vent Valve & Vent Hose
    GM561130Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. For vehicles equipped with automatic transmission, remove the right muffler. Refer to Exhaust Muffler Replacement - Right Side .
  3. Disconnect the vent hose (2) from the evaporative emission (EVAP) vent valve (1).
  4. Remove the clamp from the vent hose.
  5. Fig 2: EVAP Canister Access Cover
    GM561137Courtesy of GENERAL MOTORS CORP.
  6. Remove the right rear wheelhouse panel. Refer to Rear Wheelhouse Panel Liner Replacement .
  7. Remove the EVAP canister access cover.
  8. Fig 3: View Of EVAP Canister Vent Hose
    GM561128Courtesy of GENERAL MOTORS CORP.
  9. Disconnect the vent hose from the EVAP canister.
  10. Remove the vent hose.
  11. Cap the EVAP vent valve and the EVAP canister in order to prevent possible EVAP system contamination.