LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Corvette Z06 >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Controls And Fuel - 6.2L Or 7.0L - Repair Instructions >> Repair Instructions >> Evaporative Emission Line Replacement - Engine (Chassis/Tank) >> Removal Procedure

Removal Procedure

    Fig 1: View Of EVAP Canister Vent Valve & Bracket
    GM329567Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. For vehicles equipped with an automatic transmission, remove the right muffler. Refer to Exhaust Muffler Replacement - Right Side .
  3. Remove the evaporative emission (EVAP) vent valve (2) from the bracket (1).
    4. Fig 2: View Of Rear Purge Pipe & Chassis Purge Pipe
    GM329558Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the rear EVAP purge pipe (1) at the chassis EVAP purge pipe (3).
  5. Cap the chassis EVAP purge pipe.
    6. Fig 3: EVAP Canister Access Cover
    GM561137Courtesy of GENERAL MOTORS CORP.
  6. Remove the right rear wheelhouse panel. Refer to Rear Wheelhouse Panel Liner Replacement .
  7. Remove the EVAP canister access cover.
    8. Fig 4: View Of EVAP Canister Purge Pipe
    GM609762Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the EVAP purge pipe at the canister.
  9. Remove the rear EVAP purge pipe.
scientia non olet · About LEMON Manuals