LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Corvette Z06 >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Controls And Fuel - 6.2L Or 7.0L - Repair Instructions >> Repair Instructions >> Evaporative Emission Line Replacement - Engine (Chassis) >> Removal Procedure

Removal Procedure

    Fig 1: Chassis Purge Pipe & Engine Purge Pipe
    GM329579Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine purge pipe (1) from the chassis purge pipe (2).
  2. Cap the engine purge pipe in order to prevent possible contamination.
  3. Fig 2: EVAP Pipe Retainer & Chassis Fuel
    GM329553Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the chassis fuel and evaporative emission (EVAP) pipe retainer (1) from the upper front of dash mounting stud (3).
  5. Fig 3: Exhaust Intermediate Pipe
    GM67889Courtesy of GENERAL MOTORS CORP.
  6. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  7. Remove the exhaust intermediate pipe. Refer to Intermediate Pipe Replacement .
  8. Fig 4: View Of Driveline Tunnel Closeout Panel & Bolts
    GM67894Courtesy of GENERAL MOTORS CORP.
  9. Remove the floor panel tunnel reinforcement. Refer to Floor Panel Tunnel Panel Reinforcement Replacement .
  10. Fig 5: View Of EVAP Canister Vent Valve & Bracket
    GM329567Courtesy of GENERAL MOTORS CORP.
  11. Remove the EVAP canister vent valve (2) from the bracket (1).
  12. Fig 6: View Of Rear Purge Pipe & Chassis Purge Pipe
    GM329558Courtesy of GENERAL MOTORS CORP.
  13. Disconnect the rear purge pipe (1) at the chassis purge pipe (3).
  14. Cap the rear purge pipe.
  15. Fig 7: View Of Chassis Pipes & Underbody Retainers
    GM329574Courtesy of GENERAL MOTORS CORP.
  16. Remove the chassis purge pipe (4) rear underbody retainer nuts (3).
  17. Remove the chassis purge pipe (4) from the rear underbody retainers (2).
  18. Disconnect the chassis purge pipe (4) from the side underbody retainers (6).
  19. Remove the chassis purge pipe.