Engineering Mode Description and Operation

Engineering Mode enables some instrument identification and current status information to be displayed on the Mutli-function Display (MFD). It also provides an Instrument Self Test function. Engineering mode is entered, by switching the ignition on while pressing the ENTER button.

Engineering Mode is exited by switching off the ignition or pressing the TRIP button.

While in Engineering Mode, if one or more warnings occur they will interrupt the current display.

After all warnings have been acknowledged with the ENTER button, the previous Diagnostic Display screen is restored. Minimised Warning icons will not be shown whist Engineering Mode is active.

Navigation through the Engineering Mode menu items is via the Up/Down scroll wheel on the steering wheel.

The sequence of displays is as follows:

• Software Version
• GM Part Number
• Battery Voltage
• Remaining Fuel (Lts)
• Instantaneous Fuel (Lts)
• Coolant Temperature
• Speed (km/h)
• Tacho (rpm)
• Tyre Pressure
• Engine Oil Life (%)
• Park Lamps (on/off)
• Steering Wheel Switch Voltage
• Display of Gears (commanded)
• Throttle Position Requested (pedal %)
• Transmission Sump Temperature (°C)
• Self Test