Transmission Control Lever Knob Replacement

WARNING: This page is about a different variant/trim than selected.

Fig 1: Transmission Control Lever Knob

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the front floor console front cover. Refer to Front Floor Console Front Cover Replacement (Without UMQ) or Front Floor Console Front Cover Replacement (With UMQ) .
1	Transmission Control Lever Knob Assembly Fastener (Qty: 4)
2	Manual Transmission Control Lever Knob Assembly Procedure: First remove the 4 fasteners securing the manual transmission control lever knob assembly to the front floor console. Tip: Firmly pull upward until knob is released from control assembly. Tighten: 9 N.m (80 lb in)