LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Camaro LS, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays And Gauges >> Diagnostic Information and Procedures >> DTC B3619 >> Component Testing

Component Testing

Static Test

  1. Ignition OFF, disconnect the harness connector at the S27 Head-Up Display Switch.
  2. Test for 8.8-9.3k Ω between the signal terminal 6 and the low reference circuit terminal 1.
    • If not within the specified range, replace the S27 Head-Up Display Switch.
  3. Test for 550-650 Ω between the signal terminal 6 and the low reference circuit terminal 1 while pressing the Page switch.
    • If not within the specified value, replace the S27 Head-Up Display Switch.
  4. Test for 1.5-1.7k Ω between the signal terminal 6 and the low reference circuit terminal 1 while pressing the Up switch.
    • If not within the specified value, replace the S27 Head-Up Display Switch.
  5. Test for 3.3-3.7k Ω between the signal terminal 6 and the low reference circuit terminal 1 while pressing the Down switch.
    • If not within the specified value, replace the S27 Head-Up Display Switch.
scientia non olet · About LEMON Manuals