LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 517 (Engine Controls And Fuel - 3.6L (LLT) - DTC P0010 To DTC P0336) >> Diagnostic Information and Procedures >> DTC P0315: Crankshaft Position System Variation Not Learned >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform the scan tool Crankshaft Position Variation Learn procedure.
  2. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed in the Freeze Frame/Failure Records data.
  3. Verify the DTC is not set.
    • If the DTC sets 

      Replace the K20 Engine Control Module.

    • If the DTC does not set 
  4. All OK
scientia non olet · About LEMON Manuals