LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 517 (Engine Controls And Fuel - 3.6L (LLT) - DTC P0010 To DTC P0336) >> Diagnostic Information and Procedures >> DTC P00F4-P00F6: Intake Air Humidity Sensor >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Multifunction Intake Air Sensor

  1. Test the Intake Air Humidity Sensor by varying the air humidity in the intake duct near the sensor, while observing the scan tool Intake Air Humidity Sensor parameter. The parameter should change and be within 5-95%.
    • If not within 5-95%, or the parameter does not change. 

      Replace the K20 Engine Control Module.

    • If within 5-95% and the parameter does change 
  2. All OK.
scientia non olet · About LEMON Manuals