LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 517 (Engine Controls And Fuel - 3.6L (LLT) - DTC P0010 To DTC P0336) >> Diagnostic Information and Procedures >> DTC P0096 or P0111: Intake Air Temperature (IAT) Sensor >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Multifunction Intake Air Sensor - IAT Sensor 1

  1. Ignition OFF, disconnect the harness connector at the B75C Multifunction Intake Air sensor.
    2. NOTE:

    A thermometer can be used to test the sensor off the vehicle.

  2. Test the IAT sensor 1 by varying the sensor temperature while monitoring the sensor resistance. Compare the readings with the Temperature Versus Resistance - Intake Air Temperature Sensor (Hitachi Sensor) table for Hitachi Sensors. The resistance values should be in range of the table values.
    • If not within the table values. 

      Replace the B75C Multifunction Intake Air sensor.

    • If within the table values. 
  3. All OK

Multifunction Intake Air Sensor - IAT Sensor 2

  1. Test the IAT Sensor 2 by varying the sensor temperature while monitoring the air temperature with a thermometer. Compare the readings with the scan tool IAT Sensor 2 parameter. The values should be within 5%.
    • If not within 5% 

      Replace the B75C Multifunction Intake Air sensor.

    • If within 5% 
  2. All OK.
scientia non olet · About LEMON Manuals