LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 512 (Power Steering System) >> Diagnostic Information and Procedures >> Whine or Growl Noise from the Power Steering System

Whine or Growl Noise from the Power Steering System

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
Step Action Yes No
1 Did you review the Power Steering System Description and perform the necessary inspections? Go to Step 2  Go to Steering Wheel and Column Description and Operation
2 Verify that a whine or growl noise is present.
Is a whine or growl noise present?
Go to Step 3  System OK
3 Inspect the power steering fluid for the following indications of contamination:
  • Milky fluid - water
  • Brown Fluid - burnt
  • Debris in fluid - plastic or dirt

Is the fluid free of contamination?
Go to Step 5  Go to Step 4 
4 Flush the power steering system. Refer to Power Steering System Flushing .
Did you complete the procedure?
Go to Step 11  Go to Step 5 
5 Using the J 39570  chassis ear, inspect the power steering gear for a whine or growl noise.
Is the noise present at the power steering gear?
Go to Step 8  Go to Step 6 
6 Using the J 39570  chassis ear, inspect the power steering pump for a whine or growl noise.
Is the noise present at the power steering pump?
Go to Step 9  Go to Step 7 
7 Using the J 39570  chassis ear, inspect the power steering hoses for a whine or growl noise.
Is the noise present at the power steering hoses?
Go to Step 10  Go to Step 2 
8 Replace the steering gear. Refer to Steering Gear Replacement .
Did you complete the repair?
Go to Step 11  -
9 Replace the power steering pump. Refer to Power Steering Pump Replacement .
Did you complete the repair?
Go to Step 11  -
10 Adjust the routing of the power steering hoses.
Did you complete the repair?
Go to Step 11  -
11 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3