LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 511 (Wiper System And Washer System) >> Diagnostic Information and Procedures >> Rear Wiper System Malfunction >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

I/P Switch Assembly

  1. Ignition OFF, disconnect the harness connector at the multifunction switch - I/P.
  2. Rear wiper switch in the OFF position, test for infinite resistance between the ignition terminal 6 and the signal terminal 5.
    • If not the specified value, replace the I/P switch assembly.
  3. Rear wiper switch in the ON position, test for less than 5 Ω between the ignition terminal 6 and the signal terminal 5.
    • If not within the specified range, replace the I/P switch assembly.
scientia non olet · About LEMON Manuals